ASTM C/CM: Standard Specification for Latex Agents for Bonding Fresh To Hardened Concrete. 14 products Find ASTM C products and abstract using the BuildSite database. Get the right product for the spec. SBR LATEX is a product in the Concrete Admixtures category that meets ASTM C Find submittal-ready datasheets, SDS, specs, ICC-ES reports.
|Published (Last):||14 July 2017|
|PDF File Size:||9.97 Mb|
|ePub File Size:||2.37 Mb|
|Price:||Free* [*Free Regsitration Required]|
Print and complete the following order form. Results Produced Bond strength, bond area, number of voids in the bond and aztm and position of the failure are reported. Link to Active This link will always route to the current Active version of the standard.
ASTM C Bond Shear Strength of Latex Systems | CTLGroup
Instructions Submit 1 quart of product and desired cement if applicable. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the asm.
Use Determination of the bond strength of latex bonding systems with portland cement concrete.
Historical Version s – view previous versions of standard. If you need more info or have any questions, please note the Lab ID number and contact us at: Time for Results Please contact a CTLGroup chemical services representative or Project Manager to discuss your individual c109 needs and testing response times.
ASTM C – 99 Standard Specification for Latex Agents for Bonding Fresh To Hardened Concrete
Order Form 2 Email complete form to contact listed below. Combining values from the two systems may result in non-conformance with the standard. It is informational only and not an official part of the astmm the full text of the standard itself must be referred to for its use and application. This specification covers the requirements for latex bonding agents suitable for use in brushes, brooms, or sprays.
ASTM does not give cc1059 warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date. This method evaluates bonding hardened mortar specimens to freshly mixed specimens. Also need product MSDS and application instructions.
If dummy specimens are not available – Same would need to be cast and allowed to cure for 28 days prior to being used in bond shear test. Each material should comply with the specified bond strength requirement for either of the two types of latex.
Standard Specification for Latex Agents for Bonding Fresh To Hardened Concrete
The bonding qstm are intended for use in bonding fresh concrete to hardened concrete such as in interior surfaces, floors, roadways, bridge decks, ramps, runways, walks, and curbs. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Sample Type Latex bonding systems, Latex modified repair mortars, Latex modified concrete.